Voltage: DC 12V 2A (max.)

MODEL NO.: PB360
PACKING DIMENSION: L7cm x W2.3cm x H13.3cm
WEIGHT: 0.1KG

Installation:
• Find suitable hold size to fit the screw, if no hole to install the wires to your new push button, drill a 5mm (3/16") hole through the door frame at your chosen position.
• Carefully remove the name plate cover from the back of the push button, then remove the front cover. The front cover can be removed by inserting a small screwdriver into the slot at the side.
• From the inside, feed the bell wire through the hole in the door frame and attach the wires to the terminals on the back of the push button.

Note:
• It does not matter which wire is attached to which terminal. It is important that the wires do not touch water.
• After wiring on the write card, replace the name plate cover, fit the push button on to the door frame using the two screws provided.
• Replace the push button cover.
Beware:
The call button can only be used in low voltage electrical installations.
Do not use on mains with AC 230V power source.