Wired Push Button PB-360

Installation:

• Find suitable hold size to fit the screw, if no hole to install the wires to your new push button, drill a 5mm (3/16") hole through the door frame at your chosen position.

• Carefully remove the name plate cover from the back of the push button, then remove the front cover. The front cover can be removed by inserting a small screwdriver into the slot at the side.

• From the inside, feed the bell wire through the hole in the door frame and attach the wires to the terminals on the back of the push button.

Note:

• It does not matter which wire is attached to which terminal. It is important that the wires do not touch water.

• After wiring on the write card, replace the name plate cover, fit the push button on to the door frame using the two screws provided.

• Replace the push button cover.

Beware:

The call button can only be used in low voltage electrical installations.

Do not use on mains with AC 230V power source.